Instruction manual

TROUBLESHOOTING
45INSTRUCTION MANUAL
? Touch screen buttons do not function properly. Remove cover, press the reset
button located in the bottom left corner then accurately touch 3 target centers on
the screen when prompted.
? Air Conditioning does not turn on even when room temperature is higher then
the temperature set point set point. DHCONTROLCOMP is turned ON and dehumidify
set point has been reached. This will cause air conditioning to turn off. Lower Setpoint
- Page 17, 21; Dh CONTROLCOMP - Page 39.
? Air conditioning turns on in HEAT mode and heating turns on in COOL mode.
Reverse the OB valve (see “Advanced Settings” Page 36).
? PARTIAL LOCK and FULL LOCK do not function. You must not touch the screen
for 1 minute for Climatouch
™
to automatically lock.
? Thermostat appears normal until the screen becomes blank when the
compressor or heating system turns on. You need to connect the “C” wire. 4
wire system will not function unless the heat and compressor contactors can
supply enough current to power the thermostat with only 4 wires, if you cannot
hook up the “C” wire another possible solution is to connect one 250 ohm 10 watt
resistor in the HVAC room, for cooling problems between C and W or in the case
of heating problem between C and Y1.
? I forgot my PIN and cannot unlock the thermostat. Remove the cover plate, press
the reset button located in the bottom right corner, as soon as the message
“touch to reset password” appears touch the screen, your PIN will be erased and
the thermostat will unlock.
SIMPLE THERMOSTAT MODE
44 Climatouch
™
CT0-7TC-32ADH
>> Climatouch
™
can also function as a virtual non-programmable thermostat after
it has been switched to a “SIMPLE MODE”.
>> To enable “SIMPLE MODE”, press the reset button (take off the thermostat faceplate
and press the reset button located in the bottom right-hand corner). The message
“Touch for simple thermostat” will appear. Touch the screen immediately, and
Climatouch
™
becomes a simplified non-programmable thermostat.
>> “SIMPLE MODE” has the following temperature control modes:
>> “SIMPLE MODE” has the following fan operation modes:
Please note that when entering "Simple Mode" all configurations and settings
are stored permenantly.
>> To revert back to the Programmable Climatouch
™
Thermostat, simply press the
reset button and touch the screen when the message “Touch for Programmable
Thermostat” appears.