System information

C0240111-06-07-GB
97
10.2 Setting the board address
The board address is set by the software using the keypad.
Proceed as follows:
1 Make sure the keypad address is set to 0 (see keypad address
settings para)
Display address
Setting..........:00
I/O Board address:
2 Disconnect the board from the power supply (turn off the general
switch).
3 Power the board by pressing [ALARM] and [UP] together; hold the
keys down until the mask shown to the side appears.
pLan address: 0
UP: increase
DOWN: decrease
ENTER: save & exit
4 Set the required address (e.g.: 1 )
To do this, press [UP] or [DOWN]; press [ENTER] to confirm.
pLan address: 1
UP: increase
DOWN: decrease
ENTER: save & exit
5 An “empty” mask appears because the address of the keyboard is 0
and that of the board is (as shown in the example) 1; the two devices
cannot communicate.
In any case, board address 1 has been set.
6 Now perform “PLAN NETWORK CONFIGURATION” to allow the
board to communicate with its keypad