User's Manual

9
Step 4. Enter the desired Command function
number.
Step 5. Enter (#) to terminate the Command
Operation.
Step 6. CTC-1041RV will emit a short beep,
indicating successful programming.
The maximum interval between key strokes is
2 minutes. Otherwise, commands will be
ignored and CTC-1041RV will automatically
exit to Idle Mode.
 Any erroneous programming must be
rectified and program again correctly.
Command 01-04
Telephone Number Programming
 Used to program the 1
st
- 4
th
Tel. numbers
respectively.
 To program the 1
st
Tel. number: enter (01)
followed by (#). After one short beep, enter
(telephone number) followed by (#). The
1
st
Tel. number is programmed successfully.
 Likewise, the 2
nd
, 3
rd
or 4
th
Tel. numbers can
be programmed using Command (02), (03)
or (04) respectively.
<
<
N
N
O
O
T
T
E
E
>
>
 When entering the phone number,
entering () represent a 3-sec. pause.
(ex. Switchboard system, extension,
etc.)
 Up to 20 digits including () are
allowed for each telephone number.
Delete Telephone Number：
：：
：
 To delete the 1
st
Tel. number, enter (01)
followed by (#), after one short beep, enter
another (#). CTC-1041RV will emit another
short beep, signaling the 1
st
Tel. number is
erased.
 Likewise, you can erase the respective 2
nd
,
3
rd
or 4
th
Tel. Numbers, by following the
above procedure.
Command 05-06
Select Telephone Number for Alarm
Reporting and Status Reporting
<
<
I
I
M
M
P
P
O
O
R
R
T
T
A
A
N
N
T
T
N
N
O
O
T
T
E
E
>
>
If the Tel. number is selected in
Commands #5, #6 and #7, then
Command #7 holds the top priority to
overwrite the setting. The Tel. number
selected in Command #7 will not be
used for alarm and/or status reporting,
 Command (05): Select which telephone
number (1-4) is/are to be used for Alarm
Reporting.
 Command (06): Select which telephone
number (1-4) is/are to be used for Status
Reporting.
 Available Key-in options:
Tel. Number
Function Selection
Sequence
1
st
Tel. #
(1)
2
nd
Tel. #
(2)
3
rd
Tel. #
(3)
4
th
Tel. #
(4)
1
st
& 2
nd
Tel. #s
(12)
1
st
& 3
rd
Tel. #s
(13)
1
st
& 4
th
Tel. #s
(14)
2
nd
& 3
rd
Tel. #s
(23)
2
nd
& 4
th
Tel. #s
(24)
3
rd
& 4
th
Tel. #s
(34)
1
st
, 2
nd
& 3
rd
Tel. #s
(123)
1
st
, 2
nd
& 4
th
Tel. #s
(124)
1
st
, 3
rd
& 4
th
Tel. #s
(134)
2
nd
, 3
rd
& 4
th
Tel. #s
(234)
1
st
, 2
nd
, 3
rd
& 4
th
Tel. #s
(1234)
 Factory default is set as (1234). Alarm &
Status will be reported to all of 4 Telephone
Numbers.