User's Manual

18
 To remove a talking pendant (WTRVS)
or CTC-808RV from the Contorl Panel,
you have to remove it from the Control
Panel first and then restore the
WTRVS or CTC-808RV to factory
default.
 If the Pendant(s) you use Commands
80-84 to remove includes any WTRVS
or CTC-808RV, you will need to wait 5
to 10 seconds for the system to emit
an acknowledging beep over the
phone.
Commands 91
Learn-In Pendant #1
 Only one Pendant can be learnt into CTC-
1041RV by using Command #91.
 This command is only used for learning
WTR- Series, Fall Sensor, WTRVS, CP-23
or CTC-808RV.
 If you have learned one device into the
system by using local learning method (as
mentioned in 2.1 section), you are not
allowed to use Command 91 to learn in
another device.
 For learning Pendant #1:
Step 1: Enter 91 + # on the phone set, then
a short beep will be heart via the
phone set.
Step 2: Press the Pendant Button within 60
sec.
 Learning can only be completed
within the signal reception range of
CTC-1041RV.
 If no signal is received within 60
sec, CTC-1041RV will emit a long
beep and automatically returns to
Programming mode.
Step 3: CTC-1041RV will emit 2 beeps to
indicate that Pendant #1 is learnt-in
successfully.
 Adding a Pendant for a second
time is prohibited unless it is
removed from the system first.
 If one long beep is emitted
instead of 2 beeps, it indicates:
 The device has already been
learnt-in.
 Another device has been learnt-
in before.
Commands 92
Learn-In Pendant #2
 Only one Pendant can be learnt into CTC-
1041RV by using Command #92.
 This command is only used for learning
WTR- Series, Fall Sensor, WTRVS, CP-23
or CTC-808RV.
 If you have learned one device into the
system by using local learning method (as
mentioned in 2.2 section), you are not
allowed to use Command 92 to learn in
another device.
 For learning Pendant #2:
Step 1: Enter 92 + # on the phone set, then
a short beep will be heart via the
phone set.
Step 2: Press the Pendant Button within 60
sec.
 Learning can only be completed
within the signal reception range of
CTC-1041RV.
 If no signal is received within 60
sec, CTC-1041RV will emit a long
beep and automatically returns to
Programming mode.
Step 3: CTC-1041RV will emit 2 beeps to
indicate that Pendant #2 is learnt-in
successfully.
 Adding a Pendant for a second
time is prohibited unless it is
removed from the system first.
 If one long beep is emitted
instead of 2 beeps, it indicates:
 The device has already been
learnt-in.
 Another device has been learnt-
in before.
Commands 93
Learn-In Silent Pendant
 Only one Silent Pendant (WTR- Series, Fall
Sensor, WTRVS, CP-23 or CTC-808RV)
can be learned into CTC-1041RV by using
Command #93. When CTC-1041RV
received the alarm signal from the Silent