User's Manual

22
battery in the following cases:
 Battery switch OFF
 Battery not connected
 Battery failure.
 When the battery disconnection lasts for
10-15 mins, CTC-1041RV will report to the
Monitoring Center and the GREEN LED
flashes slowly.
 If battery disconnection persists, CTC-
1041RV will emit 2 short beeps every hour.
 The blinking status of RED LED can be
cleared by pressing the “RESET” button.
 After the battery is restored and it lasts for
10~15min, CTC-1041RV will send Battery
Restore report to Monitoring Center and
the GREEN LED returns to steady ON.
4.1.6. Devices Low Battery
 When CTC-1041RV receives a battery low
signal from a particular device, it will report
to the Monitoring Center and the GREEN
LED will flash rapidly until the fault
condition is cleared.
 In addition, CTC-1041RV will emit 3 short
beeps every hour. Press the RESET
button on CTC-1041RV will stop the
warning beeps.
 If any device Low Battery signal is
received again, the LED and warning
beeps will be performed accordingly.
Press the RESET button again to silent
the warning beeps.
 After the faulty battery is replaced, CTC-
1041RV will immediately send Battery
Restore report to the Monitoring Center for
that particular device.
4.1.7. Automatic Check-in Report =
Periodic Test Call
 When CTC-1041RV is programmed to
send a periodical check-in report, CTC-
1041RV will report to the Monitoring
Center accordingly.
 The Periodic-Check-in Timer will be reset
whenever Programming Mode is entered.
4.1.8. Mobility Timer
 In order to check the user’s well being, a
Mobility Timer can be set by using
Command #44.
 If Mobility Timer is set as Enable, a
counting down period starts from:
 Immediately after powering up CTC-
1041RV
 Exit Programming Mode
 After the pre-set Timer expires, CTC-
1041RV will emit a beep at every 5
minutes to notify the user for 30 minutes.
 When the Mobility timer is not reset after
30 minutes, CTC-1041RV will send a
Mobility Timer Expired report to the
Monitoring Center every 30 minutes until
timer is reset.
 Mobility Timer can be reset by pressing
RESET button once on CTC-1041RV or
whenever a movement is detected by PIR
Detector.
 To disable the Mobility Timer function:
 Set Command #44 to 0 (Disable), or,
 Press and hold the RESET button on
CTC-1041RV for 16 seconds or
longer.
<
<
N
N
O
O
T
T
E
E
>
>
 If no movement is detected during preset
mobility time, CTC-1041RV will send a CID
event code 641 with a fixed zone number 071
regardless of the zones the triggered motion
detectors occupy.
 Disable the Mobility function in idle
mode:
Step 1: When the system is in Idle Mode,
press & hold the Reset Button for 16
seconds.
Step 2: During the 16-sec period, CTC-
1041RV will emit one short beep  a
double beep  continuous three short
beeps  a long beep.
Step 3: Release the Reset Button when you
hear the last long beep; a short beep
will sound to indicate the mobility
function is disabled.
<
<
N
N
O
O
T
T
E
E
>
>
 Please use Command #44 to enable the
Mobility timer again.