User's Manual

VST-2735/2752 and M Series Control Panel

Step 1. Connect VST-1818 IP Camera to the same LAN as the Control Panel.

Step 2. Assuming the Control Panel is properly installed, open its webpage.

Step 3. Put the Control Panel into learning mode according to manual instruction.

Step 5. Press and hold the Privacy Button on the IP Camera for 10 seconds to enter

the learning mode. The Blue LED will start to flash.

Step 6. If the Control Panel detects the IP Camera, please refer to the Control Panel

manual on how to complete learning a device. If the IP Camera cannot be

detected, make sure the IP Camera is connected to the same local area

network (LAN), exit learning mode on the IP Camera (press the Privacy

Button for 6 seconds) and repeat.

Step 7. If learning is successful, the Blue LED on the IP Camera will stop flashing and

stay on.