User's Manual

 Press the “HOLD” button on #2130 for one full second.
 #2130 sounds one beep to confirm the “HOLD” command and will hold the system
for the Hold Length specified at programming step.
 Green LED stops flashing and Orange LED begins flashing
 You may press the Power Switch once to cancel the “HOLD” command at anytime
before the Hold Length is expired, or #2130 will sound another beep when the Hold
Length is up to warn the user.
 Orange LED stops flashing and Green LED starts to flash
 During the Hold Length period, #2130 ignores all signals received from the sensor
 After the Hold Length period expired before the patient leaves the bed, in despite,
#2130 sounds one beep to indicate it is back in Monitoring Mode.
 To extend the Hold Length:
 Press the “HOLD” button once to extend the Hold Length for a time period as
specified at pre-set.
 With a FLOOR system:
When the patient leaves the bed and steps on the sensor pad,
 Response at Patient Unit, #2130:
 Immediately, the #2130 sounds its alarm warning beep and sends out a signal
to the #2131
 After 5 seconds, #2130 will notify the Nurse Station via its nurse call jack and
the signal will repeat every 2 seconds.
 Response at Bell Box Unit, #2131:
 Once the signal is received from the #2130, #2131 fast flashes all LEDs and
cycle an alarm tone.
Reset the system:
 The nurse responds before the Alarm Length expires:
 Press the large button on the #2131 to stop sounding and lower the flashing
rate of the LEDs
 Place the patient back in BED and #2130 will then reset itself automatically.
 Press the large button on the #2131 again to reset the system, or the system
will reset automatically after 5 minutes.
 The nurse responds after the Alarm Length expired:
 Place the patient back in BED and #2130 will then reset itself automatically.
 Press the large button on the #2131 to reset the system before leaving the
room.
 If not, when it is at this semi-reset stage, #2131 will ignore all alarm signals
sent from the #2130
 If not, #2131 will reset automatically after 5 minutes.
To move the patient around and not activate the #2130,
 Press the “HOLD” button on #2130 for one full second.
 #2130 sounds one beep to confirm the “HOLD” command and will hold the system
for the Hold Length specified at programming step.