User's Manual

 Green LED stops flashing and Orange LED begins flashing
 You may press the Power Switch once to cancel the “HOLD” command at anytime
before the Hold Length is expired, or #2130 will sound another beep when the Hold
Length is up to warn the user.
 Orange LED stops flashing and Green LED starts to flash
 During the Hold Length period, #2130 ignores all signals received from the sensor
 After the Hold Length period expired, #2130 sounds one beep to indicate it is back in
Monitoring Mode.
 To extend the Hold Length:
 Press the “HOLD” button once to extend the Hold Length for a time period as
specified at pre-set.
N
N
O
O
T
T
E
E
:
:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection. This equipment generates, uses and can radiated radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user‘s authority to operate the equipment.