User's Manual

3
ZigBee Network Setup
z
z
Z
Z
i
i
g
g
B
B
e
e
e
e
D
D
e
e
v
v
i
i
c
c
e
e
G
G
u
u
i
i
d
d
e
e
l
l
i
i
n
n
e
e
ZigBee is a wireless communication protocol that is reliable, has low power consumption and has
high transmission efficiency. Based on the IEEE802.15.4 standard, ZigBee allows a large amount
of devices to be included in a network and coordinated for data exchange and signal transmission.
Due to the fundamental structure of ZigBee network, ZigBee device will actively seek and join
network after powering on. Since performing a task in connecting network may consume some
power, it is required to follow the instructions to avoid draining battery of a ZigBee device
- Ensure your ZigBee network router or coordinator is powered on before inserting battery into the
ZigBee device.
- Ensure the ZigBee network router or coordinator is powered on and within range while a ZigBee
device is in use.
- Do not remove a ZigBee device from the ZigBee network router or coordinator without removing
the battery from a ZigBee device.
z
z
J
J
o
o
i
i
n
n
i
i
n
n
g
g
t
t
h
h
e
e
Z
Z
i
i
g
g
B
B
e
e
e
e
N
N
e
e
t
t
w
w
o
o
r
r
k
k
As a ZigBee device, the PIR Camera needs to join a ZigBee network to transmit signal when a
movement is detected. Please follow the steps below to join the device into the ZigBee network.
The PIR Camera can only join ZigBee network within 3 minutes after power on.
1. Pull out the battery insulator to activate batteries.
2. Within 3 minutes after power on, Press and hold the function button for 10 seconds,
release the button when both the Blue LED and flash LED flash once.. Please make sure to
enable the permit-join feature on the router or coordinator of your ZigBee network.
3. After joining the ZigBee network, the PIR Camera will be registered in the security system in
the network automatically. Please check the ZigBee network coordinator, system control
panel, or CIE (Control and Indicating Equipment) to confirm if joining and registration is
successful.
4. After joining the ZigBee network, if the PIR Camera loses connection with the ZigBee
network, the LED will flash 20 minutes to indicate. Please check your ZigBee network
condition and PIR Camera signal range to correct the situation.
z
z
F
F
a
a
c
c
t
t
o
o
r
r
y
y
R
R
e
e
s
s
e
e
t
t
If you want to remove the PIR Camera from the current network and join a new network, you need
to use the Factory Reset function to clear the PIR Camera for its stored setting and information first
before it can join another network. To perform Factory Reset:
1. The PIR Camera can only be reset within 3 minutes after power up. If the PIR Camera has
been powered up for more than 3 minutes, remove and reinsert the battery.
2. Press and hold the function button for 10 seconds, release the button when both the Blue
LED and flash LED flash once.
3. The PIR Camera has been reset to factory default setting with all its previous network
information removed. It will now actively search for available ZigBee network again and join
the network automatically.
4. If the PIR Camera successfully joins a ZigBee network, the Blue LED will flash twice to
indicate.