Parts List

 Press and hold the function button for 3 seconds, release the button when the Blue LED light on, the Blue LED
will light on for 25 seconds in learning mode, add PIR Camera into the Control Panel during this period (refer to
your Control Panel to finish learn in process). If the PIR is successfully added into the Control Panel, the Blue
LED will flash 6 times to indicate. If PIR is not added within 25 seconds, please repeat learning process.
<NOTE>
 If the PIR Camera already exists in a Control Panel system, you will need to first remove the PIR Camera
from the Control Panel before you can learn it into a different Control Panel.
 When learning the PIR Camera into a repeater/router, please press the function button once (instead of
pressing and holding it for 3 seconds) to send a learn code. (P5 models only)
 Walk Test
 After the PIR Camera is learnt-in, put the Control Panel into “Walk Test” mode, hold the PIR Camera in the
desired location, and press the Function Button to confirm this location is within signal range of the Control Panel,
refer to Control Panel manual to complete Walk Test.
 When you are satisfied that the PIR Camera works in the chosen location, you can proceed to mounting.
 Edit PIR Camera Operation Area
 Follow instruction below to change PIR Camera Area in the Control Panel
1) Use the panel Edit Device function to change PIR Camera area setting.
2) Press and hold the Test button for 3 seconds on the PIR Camera to send a signal to the panel, and then
release the button when the LED lights up.
Installation
 Installation Guideline
 The PIR Camera is designed to be mounted on either a flat surface or in a corner situation with fixing screws and
plugs provided.
 The base has knockouts, where the plastic is thinner, for mounting purpose. Two knockouts are for surface fixing
and a triangular mounting bracket is used for corner fixing.
 The detection range is up to 12 meters if the PIR Camera is mounted 2 meters above ground.
 The Pet-Immune models give a typical PET IMMUNE range of 7 meters when mounted at 1.9 to 2 meters above
ground. If required, you can adjust the height of the PIR Camera according to the size of your pet for optimal pet
immune performance. Higher installation location will provide larger pet-immune space, but also increases the
blind spot under the PIR Camera.
It is recommended to install the PIR Camera in the following locations
 Mount where the animals cannot come to the detection area by climbing on furniture or other objects.
 Don’t aim the detector at stairways the animals can climb on.
 In a position such that an intruder would normally move across the PIR’s field of view.
 Between 1.9 and 2m above ground for best performance.
 In a corner to give the widest view.
 Where its field of view will not be obstructed e.g. by curtains, ornaments etc.
 Limitations
 Do not install the PIR Camera completely exposed to direct sunlight.
 Avoid installing the PIR Camera in areas where devices may cause rapid change of temperature in the
detection area, i.e. air conditioner, heaters, etc.
 Avoid large obstacles in the detection area.
 Not pointing directly at sources of heat e.g. Fires or boilers, and not above radiators.
 Avoid moving objects in the detection area i.e. curtain, wall hanging etc.
 Be sure to always remain the RSSI signal strength steady at “4”.
3