Installation Instructions

Step 4: Remove the LED cover by releasing the 4 screws securing the cover using a Philips screwdriver and removing the cover.

Step 5: Slide the Power switch to the OFF terminal and (where applicable) disconnect the power adapter.

Step 6: Insert batteries into battery compartment.

Step 7: Press and hold the Learn Button for 7 seconds and slide the Power switch to BT4 terminal. The Bellbox will emit two beeps followed by

one long beep.

Step 8: Release the Learn Button when you hear the long beep. The previous parameters in the Bellbox will be cleared and it will return to normal

mode.