Installation and Operation Guide

11

Enter a report destination. The format of the report destination will depend
on the Reporting Format (Type). Please see Report Destinations below.
If there are no report destinations programmed, CH-MG will not report upon
alarm activation and will emit 1 beep as a reminder.
2. Event Filter
Select an event filter. The event filter determines which events are reported
to the selected Report Destination.
3. Reporting Format (Type)
Select a reporting format. The reporting format determines how the events
are reported to the Report Destination.
4. (Reporting) Groups
Assign the Report Index to a Reporting Group. The Reporting Group
determines the sequence of reporting.
Click “Write” to apply the settings to CH-MG.
Report Destinations
After Report Format is determined, enter the Report Destinations according to
the designated Report Format:
 JSON reporting: http://iota.medicalguardian.com
JSON udi: Please input the device UDI (Unique Device Identifier) for
JSON Report. Maximum of 15 numeric characters or alphanumeric letters.
 Speech reporting and SMS Text Report Format: PhoneNumber
Example: 0912345678
Speech Reporting: When activated, CH-MG will dial to the telephone
number and open two-way voice communication directly.
SMS Text Reporting: When activated, CH-MG sends a SMS text
message to the recipient. The message contains event information.
 If two-way communication is required after an IP or SMS report, please
program a separate Speech Report. Alternatively, the user can also utilize
Callback operation.
Event Filter
This parameter determines which events are reported to the selected Report
Destination.
3 options: “All”, “Emergency” and “Status”. When an event is triggered, it will
be reported to the reporting destination according to the setting. If set to All,