Installation and Operation Guide

21

4.2. SMS Remote Programming
Step 1. Enter the SMS screen on your mobile phone or smartphone.
Step 2. Enter the programming command (see the SMS remote programming
commands tables below).
Step 3. Enter a colon (:).
Step 4. Enter SMS Keyword (default is PROG).
Step 5. Enter a comma (,).
Step 6. Enter the Access Code (default is 1111).
Step 7. Enter a comma (,).
Step 8. Enter the parameter(s).
Step 9. The composition of the command is completed. You can send the
command to CH-MG now.
<
<
N
N
O
O
T
T
E
E
>
>
 If the SMS message text format of your mobile phone is not English,
please change it to English for SMS remote programming.
Example: To set IPOG as the keyword, you can send the following command:
SUPPR:PROG,1111,IPOG
SUPPR = Programming command
: = Colon
PROG = SMS Keyword
, = Comma
1111 = Access Code
, = Comma
IPOG = Programmed parameter
<
<
N
N
O
O
T
T
E
E
>
>
 You can compose multiple commands in one SMS text message by using
“;” to separate each command.
Please refer to the Appendix for the 7.1. SMS Remote Programming
Commands Table.