Installation and Operation Guide

22

5. Local RF Device Management
CH-MG can learn up to 15 RF devices which can be used to activate CH-MG
to make emergency report.
Entering Learning Mode
Press the Learn Button of CH-MG for 6 seconds. CH-MG will emit one beep at
1
st
, 3
rd
and 6
th
second. Release the button after the beep at 6
th
second to enter
learning mode. CH-MG will play voice prompt “Entering Pairing Mode, press
the button on the peripheral to connect to the device.”
Device Learning and Testing
Step 1. Press the Button on RF device to transmit signal. Refer to RF device
manual for detail.
Step 2. CH-MG will emit 2 beeps when it receives the signal from the pendant
to indicate it has learned in the pendant.
Step 3. Repeat Step 2~3 to learn in all devices, device learnt in will be
assigned from Zone 1 to 15 in sequence.
To test learnt in device, press the device button again after learning,
CH-MG will emit a long beep if it successfully receives signal from
already learnt in device.
After complete learning, press the Learn Button on CH-MG once to exit
learning mode. CH-MG will emit 1 beep.