Installation and Operation Guide

24



6.2. Current Operation Condition

CH-MG uses its LED to remind the user of its Current Operation Condition.

 LED indicators:

LED Behavior Indication

LED (Red) Flash During Guard Time

LED (Blue) 1 Flash every 2 seconds In learning mode

LED (Amber) All LEDs On During Remote Update

1 Flash every 3 seconds Panel Low Battery/ Cellular

Network fault/battery

disconnected

1 Flash every 5 seconds Device low battery/Device

tamper/Device out-of-order

LED (Green) ON AC power connected

Flash AC power disconnected

If CH-MG is activated while having a Cellular Network fault (Amber LED

flashes once every 3 seconds), it will play voice prompt “Poor cellular

connection. Please call 911.”

6.3. Test Mode

 Test Mode is for user to test if the CH-MG can make a successful report to

the CMS.

 To enter Test Mode:

Step 1. Press and hold the Info button for 3 seconds. CH-MG will emit

one beep at 1

and 3

second. Release the button after the beep

at 3

second to enter Test mode.

Step 2. CH-MG will play voice prompt “Entering Test Mode, press the

Help Button to connect to the test center.”

Step 3. Press the Help Button once to continue with the Test. If no action

is taken, CH-MG will come out of test mode in 5 minutes.

6.4. Alarm Activation

 When an alarm is activated by pressing the Help Button of CH-MG or the

learnt-in RF device (WTR, Fall Sensor or PB), or pulling the cord of PCU,

CH-MG will emit a voice prompt “Connecting” as it enters guard time

(default 10 seconds).

If alarm is activated by fall detection, CH-MG will enter guard time fall

sensor (default 30 seconds).