Installation and Operation Guide

29

Group 1 > Group 3 > Wait 5 minutes > Group 1 > Group 3 >
Wait 5 minutes > Group 1 > Group 3 > Stops reporting
 Status Events:
CH-MG will only go through one reporting cycle for Status reports
and will not retry if report failed.
For example, if Groups 1 and 3 are programmed for “Status”
reports:
Group 1 > Group 3 > Stops reporting
6.5. Check Panel Status
To check CH-MG’s status, press the info button once in normal mode. The
panel will play voice prompt to annouce the panel state including cellular signal
strength/power status/system status.