Installation and Operation Guide

6

3.4. Software Installation (For PC Programming)
3.4.1. Installing USB Driver
CH-MG can be programmed via USB port connection of a computer using the
PC Programming Tool software (using the Programming Cable).
If the computer cannot recognize the USB connection, please try installing the
USB driver as instructed below.
Step 1. Make sure CH-MG is connected properly (please refer to 3.3.
Hardware Installation)
Step 2. Please go to http://www.ftdichip.com/Drivers/VCP.htm. Scroll down
the webpage and select the driver file according to your operation
system, download and install the driver.
3.4.2. Installing PC Programming Tool
PC Programming Tool for CH-MG is a portable application and requires no
installation. After installing the USB driver, simply unzip the file to a desired
folder and execute the “Mobile_Tool_MG.exe” file.