User's Manual

7
Short beep: Command succeeded
Long beep
: Command failed
4. Function Selection
= According to
different Command you will have different
entering in this part, e.g. Tel. Number,
Account number, etc.
5. # = Terminates Function Selection
6. ACK = Function Selection
Acknowledgement
On CTC-1052:
Short beep
: Command succeeded
Long beep
: Command failed
On the programming phone set:
Short beep
: Command succeeded
Long beep
: Command failed
z Follow the Command Steps to program
your CTC-1052:
Step 1. Enter Command number (DTMF
Numeric Command, ex. (01), (02)…)
Step 2. Press (#) to terminate the DTMF
Command.
Step 3. One short beep will be heard for
successful Command entry.
Step 4. Enter the desired Command function
number.
Step 5. Enter (#) to terminate the Command
Operation.
Step 6. CTC-1052 will emit a short beep,
indicating successful programming.
The maximum interval between key strokes is
2 minutes. Otherwise, commands will be
ignored and CTC-1052 will automatically exit
to Idle Mode.
z Any erroneous programming must be
rectified and program again correctly.
Command 01-04
Telephone Number Programming
z Used to program the 1
st
- 4
th
Tel. numbers
respectively.
z To program the 1
st
Tel. number: enter (01)
followed by (#). After one short beep, enter
(telephone number) followed by (#). CTC-
1052 will emit one beep signaling the 1
st
Tel. number was programmed successfully.
z Likewise, the 2
nd
, 3
rd
or 4
th
Tel. numbers can
be programmed using Command (02), (03)
or (04) respectively.
<
<
N
N
O
O
T
T
E
E
>
>
) When entering the phone number,
entering (À) means a 3-sec. pause.
(ex. Switchboard system, extension,
etc.). For example, the phone number
is 21111111 and extension number is
255. Enter: 21111111*255.
) Up to 20 digits including (À) are
allowed for each telephone number.
Delete Telephone Number：
z To delete the 1
st
Tel. number, enter (01)
followed by (#), after one short beep, enter
another (#). CTC-1052 will emit another
short beep, signaling the 1
st
Tel. number is
erased.
z Likewise, you can erase the respective 2
nd
,
3
rd
or 4
th
Tel. Numbers, by following the
above procedure.
Command 05-06
Select Telephone Number for Alarm
Reporting and Status Reporting
<
<
I
I
M
M
P
P
O
O
R
R
T
T
A
A
N
N
T
T
N
N
O
O
T
T
E
E
>
>
If the Tel. number is selected in
Commands #5, #6 and #7, then
Command #7 holds the top priority to
overwrite the setting. The Tel. number
selected in Command #7 will not be
used for alarm and/or status reporting.
z Command (05): Select which telephone
number & GPRS/IP (1-6) is/are to be used
for Alarm Reporting.
z Command (06): Select which telephone