User's Manual

11
Command 34
Emergency Button Enable
z The RED HELP BUTTON can be enabled
or disabled to send an Emergency alarm
report:
Function
Selection
Result
(0)
OFF
(Deactive)
(1)
ON
(Active)
z Factory Default is set as (1), ON.
<
<
N
N
O
O
T
T
E
E
>
>
) When this function is programmed as
OFF, the RED HELP BUTTON is
deactivated.
) When this function is programmed as
ON, the RED HELP BUTTON is
activated. When pressed, it will send
an Emergency alarm report to the
Monitoring Station.
Command 35
Silent Mode
z CTC-1052 can be selected to operate in
Silent Mode. This will mute all normal
operation warning beeps, guard time
tone, key tone and ring.
<
<
N
N
O
O
T
T
E
E
>
>
) In silent mode, the speaker still
functions normally for two-way voice
communication.
Function
Selection
Result
(0)
ON
(Silent)
(1)
OFF
(Normal)
z Factory Default is set as (1), OFF.
Command 37
AC Fault Report
z The CTC-1052 can be programmed to
send a Fault Report when an AC power
failure is detected.
Function Selection Result
(0)
OFF
(Send No Report)
(1)
ON
(Send Report)
z Factory Default is set as (1), ON.
<
<
N
N
O
O
T
T
E
E
>
>
) Reporting will only be made after a
continuous one hour of AC Fault
condition is detected.
Command 38
Follow-On & Call-Back Function
z The Command is available for Digital
Reporting Methods (when Command #20 -
#24
is set as (0), (1) or (2))
Function Selection Result
(0) Follow-On
(1) Call-Back
(2) Follow-On & Call-Back
z Factory Default is as (0), Follow-On.
z When this function is programmed as (0),
after a successful reporting to the
Monitoring Center, CTC-1052 will
automatically enter the Follow-On mode as
specified by Command (45).
z When this function is programmed as (1),
after a successful reporting to the
Monitoring Center, CTC-1052 will
automatically hang up the line and start a
5-minute waiting period to auto answer any
incoming phone calls from the Monitoring
Center.
z When this function is programmed as (2),
after a successful reporting to the
Monitoring Center, CTC-1052 will