User's Manual

13
<
<
N
N
O
O
T
T
E
E
>
>
) Whenever programming mode is
accessed, CTC-1052 will reset the
Periodic Test Call timer.
) Periodic Test Call will only function
with telephone numbers assigned to
Digital or SMS reporting method in
Command 20-24.
Command 44
Mobility Timer
This function monitors user movement around
the premises and sends an inactivity report to
the Monitoring Center if the user fails to reset
the inactivity timer.
z This will disable or enable the Inactivity
Timer with selectable count down periods.
Options are:
Function
Selection
Result
(00) DISABLE
(01) 1HR
(02) 2HR
..........
.........
(36) 36HR
z Factory Default is set as (00), DISABLE.
<
<
N
N
O
O
T
T
E
E
>
>
) The Mobility Timer counting down can
be reset by:
1. Pressing the RESET button on
CTC-1052, or,
2. Movement detected by PIR
Detector
3. Only workable by entering 2 digits.
) When Mobility Timer expires and no
reset signal is received, CTC-1052
starts to emit one long beep every 5
minutes to alert the user. After 30
minutes, if reset signal is not received,
a mobility alarm reporting will be made.
) The reporting method for mobility alarm
is the same as the emergency alarm.
The report will be sent based on your
reporting methods without guard time
waiting.
) When (00) is selected, no code is sent
to Monitoring Center.
) When CTC-1052 is in idle mode, press
and hold the green reset button for 16
seconds, until you hear a long beep.
Then release the button; the Mobility
function will be disabled.
Command 45
Follow-On Mode Choice
z This Command is only available for Digital
reporting with Command #38
set as (0) or
(2).
z It is used to select the Follow-On Choice
for CTC-1052 after it has made a report to
the Monitoring Center.
z After reporting, CTC-1052 can wait for
further commands, or enter a Two-Way
Full Duplex Communication, or Listen-In
Half Duplex Communication immediately
according to the setting under this
command:
Function
Selection
Result
(0)
WAIT
COMMAND
(1) LISTEN
(2) TWO WAY
z Factory Default is set as (2), TWO WAY.
<
<
N
N
O
O
T
T
E
E
>
>
) When (0) is selected, after CTC-1052
has made a report to the Monitoring
Center, it will wait for 1-10 minutes (set
by Cammand 46), and then follows the
DTMF commands that are received
from the Central Monitoirng Station for
action.
If no command is received after the
waiting period, the system will
automatically return to Idle mode.
) When (1) is selected, after CTC-1052
has made a report to the Monitoring