User's Manual

15
(3) 6 Days
(4)
7 Days
(5)
8 Days
(6) 9 Days
(7) 10 Days
z Factory default is set as (0) Disable. No
code is sent to Monitoring Center.
z When the supervisory timer expires and no
supervision signal is received from WTR-,
the supervisory alarm reporting will be
made.
z The reporting method for supervisory alarm
is the same as the emergency alarm. The
report will be sent based on your reporting
methods without guard time waiting.
Command 61
Check SIM Card PIN Code
This option is used to check SIM card PIN
Code.
Function Selection Result
(0)
OFF
(Disable)
(1)
ON
(Enable)
z Factory default is set as (0) OFF.
<
<
N
N
O
O
T
T
E
E
>
>
) If this fuction is disabled, the system
won’t check the entered SIM Card PIN
Code set by Command 62.
) If the SIM card PIN Code is entered, be
sure to enable this function.Otherwise,
the SIM card will be locked
Command 62
Input SIM Card PIN Code
z This function is used to input SIM card PIN
Code. To input a SIM Card Pin Code: 4 ~
8 digits
z Factory default is set as (Null).
<
<
N
N
O
O
T
T
E
E
>
>
) Whenever a SIM Card PIN code is
entered, the system will check if the
entered PIN code is matched. If not,
the SIM card will be locked.
) This function is not used to change
SIM Card PIN Code. If you want to
change your SIM Card PIN Code,
please use your cell phone to change
it.
) If the SIM Card is locked, please
contact your local telecommunication
service provider.
Command 63
Speaker Volume Adjustment
z This function is used to adjust speaker
volume. To set speaker volume in different
communication channels, please set
different parameters.
Function
Selection
Result
(2) Two-way
z To set speaker volume in two-way modes,
the sequence is:
Communication
Channel
DTMF Speaker Volume
2 * 1 to 5
* Communication Channel: 1 digit ( 2: Two-way)
* Be sure to put * between communication channel value
and speaker volume value.
z To set the speaker volume with a number,
ranging 1 to 5. The higher the value, the
louder the voice. Factory default is set as
(3) for Two-Way mode.
z Please refer to programming command
table section for configuration.
z Example: if you want to raise the speaker
volume to level 5 in the Two Way mode,
please enter: 2*5
<
<
N
N
O
O
T
T
E
E
>
>
) The volume value in the Listen In or
Talk-Only mode is adjusted for the
best communication quality. It is fixed
and can not be changed.