User's Manual

17
z If you have learned one device into the
system by using local learning method (as
mentioned in 2.1 section), you are not
allowed to use Command 91 to learn in
another device.
z For learning Pendant #1:
Step 1: Enter 91 + # on the phone set, then
a short beep will be heard via the
phone set.
Step 2: Press the Pendant Button within 20
secs.
) Learning can only be completed
within the signal reception range of
CTC-1052.
) If no signal is received within 20
sec, CTC-1052 will emit a long
beep and automatically returns to
Programming mode.
Step 3: CTC-1052 will emit 2 beeps to
indicate that Pendant #1 is learnt-in
successfully.
) Adding a Pendant for a second
time is prohibited unless it is
removed from the system first.
) If one long beep is emitted
instead of 2 beeps, it indicates:
9 The device has already been
learnt-in.
9 Another device has been learnt-
in before.
Command 92
Learn-In Pendant #2
<
<
N
N
O
O
T
T
E
E
>
>
) This command is not available in
Remote Programming Mode.
z Only one Pendant can be learnt into CTC-
1052 by using Command #92, including
WTR- Series or Fall Sensor.
z If you have learned one device into the
system by using local learning method (as
mentioned in 2.2 section), you are not
allowed to use Command 92 to learn in
another device.
z For learning Pendant #2:
Step 1: Enter 92 + # on the phone set, then
a short beep will be heard via the
phone set
.
Step 2: Press the Pendant Button within 20
secs.
) Learning can only be completed
within the signal reception range of
CTC-1052.
) If no signal is received within 20
sec, CTC-1052 will emit a long
beep and automatically returns to
Programming mode.
Step 3: CTC-1052 will emit 2 beeps to
indicate that Pendant #2 is learnt-in
successfully.
) Adding a Pendant for a second
time is prohibited unless it is
removed from the system first.
) If one long beep is emitted
instead of 2 beeps, it indicates:
9 The device has already been
learnt-in.
9 Another device has been learnt-
in before.
Command 93
Learn-In Silent Pendant
<
<
N
N
O
O
T
T
E
E
>
>
) This command is not available in
Remote Programming Mode.
z Only one Silent Pendant can be learnt into
CTC-1052 by using Command #93.
z For learning Silent Pendant:
Step 1: Enter 93 + # on the phone set, then
a short beep will be heard via the
phone set
.
Step 2: Press the Pendant Button within 20
secs.
) Learning can only be completed
within the signal reception range of
CTC-1052.
) If no signal is received within 20
sec, CTC-1052 will emit a long
beep and automatically returns to
Programming mode.
Step 3: CTC-1052 will emit 2 beeps to
indicate that Silent Pendant is
learnt-in successfully.
) Adding a Pendant for a second
time is prohibited unless it is