User's Manual

19
3.3. SMS Remote
Programming
<
<
N
N
O
O
T
T
E
E
>
>
) Prior to procced, please be reminded to
change the language setting of your
mobile phone to English.
Step 1: Use your handset and go into the SMS
edit screen.
Step 2: Enter the SMS keyword (default is
PROG
).
Step 3: Enter a space.
Step 4: Enter the access code (default is 1111
as defined by Command 40).
Step 5: Enter a space.
Step 6: Enter the programming command.
Step 7: Editing is complete; you may send to
the Control Panel.
<
<
E
E
X
X
A
A
M
M
P
P
L
L
E
E
>
>
E.g. PROG_1111_ TEL1:0227940001
PROG
Æ
SMS Keyword
__
Æ
Space
1111
Æ
Access Code
__
Æ
Space
TEL1
Æ
Telephone number 1
：
Æ
Colon
0227940001
Æ
Programming
data/option
<
<
N
N
O
O
T
T
E
E
>
>
) For a complete list of SMS commands,
please refer to section 5.5. CTC-1052
SMS Remote Programming
Command Table.
4. Operation
4.1. Idle Mode
When the system is in Idle Mode, CTC-1052 is
ready to execute the following functions:
4.1.1. Answering Incoming Phone Calls
This function is only available when Command
#31 is set as ON (factory default is OFF).
z For an Incoming telephone call, CTC-1052
will emit cycles of 2 quick beeps.
z User can answer the call either by
pressing the Pendant Button
or the RED
HELP BUTTON on CTC-1052.
z Once CTC-1052 answers the call, it will
open a Two-Way Voice Communication.
The RED HELP BUTTON illuminates.
 Enter (7) to Speaker Volume Control
and then press (6) or (4) to increase
or decrease the levels of speaker
volume in the “Two-Way”
communication modes.
 Enter (8) to Microphone Sensitivity
Control and then press (6) or (4) to
increase or decrease the levels of
microphone sensitivity in the “Two-
Way” communication mode.
<
<
N
N
O
O
T
T
E
E
>
>
) Please note that if you wish to enable a
designed shortcut function, please press
DTMF keys over 1 second to enable the
function you desire.
If levels of speaker volume and
microphone are adjusted in the two-way
communication mode, the adjusted value
will be kept at next use.
) To hang-up, press either the Pendant
Button
again, the RESET button on CTC-
1052. , or press DTMF 9
by the caller.
) To hang-up, the caller can press DTMF 9
or just put the handset back into the base
cradle.
) 30-minute is allowed for each call and is
inextensible.