User's Manual

22
z Disable the Mobility function in idle
mode:
Step 1: When the system is in Idle Mode,
press & hold the Reset Button for 16
seconds.
Step 2: During the 16-sec period, CTC-1052
will emit one short beep Æ a double
beep Æ continuous three short beeps
Æ a long beep.
Step 3: Release the Reset Button when you
hear the last long beep; a short beep
will sound to indicate the mobility
function is disabled.
<
<
N
N
O
O
T
T
E
E
>
>
) Please use Command #44 to enable the
Mobility timer again.
4.1.9. No Pendant Present
z This function is only available for the
digital Contact ID reporting method.
z If there is no pendent being learnt into
CTC-1052 30 mins after powering up, it
will send a No Pendant Learnt-in report
to the Monitoring Center and repeat every
hour thereafter, until a pendant is
successfully learnt in.
<
<
N
N
O
O
T
T
E
E
>
>
) If no pendant is learned into CTC-
1052, CTC-1052 will send a CID event
code 333 with a fixed zone number
072.
4.1.10. Country Code
The Phone Number Format for each SIM card
may vary between different Telecom
companies. Thus, you can either check with
your Telecom provider or follow the steps
described below to check the correct format.
Step 1: Remove the SIM card from SIM card
holder on the Panel, and insert it into
a workable mobile phone.
Step 2: Power on the mobile phone and send
a test SMS message to another
mobile telephone number.
Step 3: Once the test message is received,
you can then check the phone
number format shown in the received
message.
<
<
E
E
X
X
A
A
M
M
P
P
L
L
E
E
>
>
With the phone number 0987654321, the
format should either INCLUDE or EXCLUDE
Contry Code, which is “886” for Taiwan as
below:
INCLUDE
Country Code
[phone]
EXCLUDE
Country Code
0987654321
Step 4. Remove the SIM card from the Mobile
phone and insert it back into SIM
Card holder on Panel.
A. If the Phone Number Format EXCLUDES
Country Code, please skip this section.
B. If the Phone Number Format INCLUDES
Country Code, please proceed to SMS
Remote Program and send in this format:
“PROG 1111 REPLA:886&0”
Where:
PROG = SMS Keyword
1111 = Access Code
REPLA = SMS command for Country
Code
886 = number to be replaced
0 = number to substitute
After this is completed, Country Code “886”
will be replaced by “0”.
4.2. Alarm Activation
z When an alarm is triggered, CTC-
1052 will enter the Guard Time Delay
period (see Command 42), both RED
LED and RED HELP BUTTON
backlight turn on steadily.
 During the Guard Time period,
pressing the RESET
button on CTC-
1052, it will cancel the alarm signal
and return to Idle Mode.
 If the Guard Time Delay is set as 00,
CTC-1052 will dial immediately.
z The Alarm reporting cannot be
cancelled by pressing the RESET
button on CTC-1052 after the Guard
Time Delay expires.