User's Manual
5
2.2. Learning Pendant #2
Step 1. From Idle mode, press and hold the
RESET button for 6 seconds
Step 2. Once pressed, a button beep sound
will be heard. CTC-1052 will emit one
short beep at 3 sec., then a double
beep when it reaches 6 sec.
Step 3. Release the button after you heard the
double beep
. Then, a short beep will
be heard, indicating CTC-1052 is now
in Learning Mode. The RED LED
begins to flash.
Step 4. Press both the HELP
and Pendant #2
buttons simultaneously until CTC-
1052 emits a double-beep to indicate
that the Pendant #2 has been learned-
in successfully.
<
<
N
N
O
O
T
T
E
E
>
>
) It is prohibited to learn-in another or the
same Pendant twice (CTC-1052 will
emit a long beep instead of double-
beeps), unless the previously learnt
pendant is removed first.
Step 5. Carry the Pendant & walk around
your house. Press the Pendant
button as you move and observe the
maximum range for its operation.
If CTC-1052 responds with one long
beep, the Pendent is within the
operation range.
Step 6. Press both RESET & HELP
buttons at
the same time to exit Learning Mode.
Or, CTC-1052 will exit Learning mode
automatically after 5 mins of inactivity.
CTC-1052 will emit a short beep and
the LED turns off to indicate the
system is back to Idle mode.
2.3. Removing Pendant #1 &
Pendant #2
Step 1. From Idle mode, press and hold the
RESET button for 6 seconds.
Step 2. Once pressed, a button beep sound
will be heard. CTC-1052 will emit one
short beep at 3 sec., then a double
beep when it reaches 6 sec.
Step 3. Release the button after you heard the
double beep
. Then, a short beep will
be heard, indicating CTC-1052 is now
in Learning Mode. The RED LED
begins to flash.
Step 4. Press & hold the RESET
key again for
6 seconds (once pressed, a button
beep sound will be heard. CTC-1052
will emit one short beep at 3 sec., then
a long beep when it reaches 6 sec.)
Step 5. Release the button after you heard the
long beep
. Both Pendants have been
removed.
Step 6. Press both RESET & HELP
buttons at
the same time to exit Learning Mode.
Or, CTC-1052 will exit Learning mode
automatically after 5 mins of inactivity.
CTC-1052 will emit a short beep and
the LED turns off to indicate the
system is back to Idle mode.