User's Manual

27
31# Ringer Enable for Incoming Calls:
- When disabled, CTC-1052-QT-DT35A will operate silent for an incoming call.
- When enabled, CTC-1052-QT-DT35A will sound a ring tone as an audio alert for an incoming
call. The user can answer the incoming call by pressing the HELP BUTTON or Pendant Button.
32# Audible Fault Alert:
- When turned on, CTC-1052-QT-DT35A will sound warning beeps every 30 seconds for AC
Failure.
- When turned off, CTC-1052-QT-DT35A will NOT sound warning beeps for a fault situation.
34# Emergency Button Enable:
- When this function is programmed as Button On, the HELP BUTTON is activated. When
pressed, it will send an Emergency alarm report to the Monitoring Station.
- When this function is programmed as Button Off, the HELP BUTTON is deactivated.
35# Silent Mode:
- When Silent Mode is On, all normal operation warning beeps, guard time tone, key tone and
rings will be silenced. Speech Reporting made under Silent Mode will automatically be switched
to Listen-in, but call recipient can press DTMF keys to open two-way communication or change
modes.
- If Ringer is Enabled for Incoming Calls, CTC-1052-QT-DT35A will emit ring tone for incoming
calls even in silent mode.
- Silent mode will not mute the long beep emitted during walk test.
- When Silent Mode is Off, all warning beeps, guard time tone, key tone and rings will function
noramlly.
37# AC Fault Report:
- When set to ON, CTC-1052-QT-DT35A will send a Fault Report after a continuous one hour of
AC Fault condition is detected.
- When set to OFF, CTC-1052-QT-DT35A will not send an AC fault report.
38# Follow-On & Call-Back Function:
- When selected as “Follow-On”, after a successful reporting to the Monitoring Center, CTC-
1052-QT-DT35A will automatically enter the specific Follow-On mode as specified by
Command (45). (Reserved)
- When selected as “Call-Back”, after a successful reporting to the Monitoring Center, CTC-