User's Manual

46
 When the Test Button of the Smoke
Detector (SD) is pressed.
 120 - Fall emergency
 When Fall Sensor is triggered
 147 - Sensor Supervisory Failure
 When CTC-1052-QT-DT35A is unable
to receive the signal transmitted from
the Wrist Transmitter for a pre-set
period by Command #49, the Green
LED will flash every 2 seconds.
 154 - Water emergency
 When Water Sensor (WS) is triggered
 158 - Low temperature report
 When temperature is below Low
Temperature Reporting Threshold
 159 - High temperature report
 When temperature is above High
Temperature Reporting Threshold
 162 - Carbon Monoxide emergency
 When Carbon Monoxide Detector (CO)
is triggered
 When the Test Button of Carbon
Monoxide Detector (CO) is pressed.
 176 - Carbon Dioxide Alarm
 When CO2 concentration value
reaches or exceeds the Alarm
Reporting threshold.
 301 - Panel AC Failure
 When AC power fails for more than 10
sec, the Green LED flashes every sec
with a beep every 30 seconds.
 302 - Panel Low battery
 When CTC-1052-QT-DT35A is under
Low Battery status, the Green LED
flashes every 2 seconds.
 311 - Panel Battery Disconnection
 When CTC-1052-QT-DT35A is under
Battery Not Connected status, the
Green LED flashes every 2 seconds.
 373 - Smoke Low Battery
 When Smoke Detector is under Low
Battery Status, the Green LED flashes
every 2 seconds.
 380 - WTR Low Battery
 When Wrist Transmitter / Emergency
Pendant (WTR) is Low on Battery, the
Green LED flashes every 2 seconds.
 383 - IR Tamper open
 When the IR Tamper is opened.
 384 - Other devices Low Battery
 When other devices are under Low
Battery Status, the Green LED flashes
every 2 seconds
 601 – Manual trigger Test Report
 When the Test Button is pressed, test
report is sent to monitoring center.
 602 - Periodic Test Report
 When CTC-1052-QT-DT35A reports
Periodic test call to monitoring Center.
 606 - Follow-On Function
 When CTC-1052-QT-DT35A receives
kiss-off from Monitoring Center for
opening Speech channel.
 611 - Global test
 When CTC-1052-QT-DT35A reports
Global Test to Monitoring Center.
 641 - Mobility
 When CTC-1052-QT-DT35A makes
Mobility Timer Expired reporting.
<NOTE>
 This event code will be sent with a fixed
zone number of 071
 706 - Medication Non-Adherence
 When the scheduled-dose is still not
taken after “Time for Medicine” alarm
expires (default: 30 minutes).
 707 - Medication Dispenser Mechanism
Jam
 When the Medication Dispenser is
jammed (e.g. White T-Bar not in the
correct position).
 301 - Medication Dispenser AC Fail
 When AC Power for the Medication
Dispenser fails and lasts for 24 hours.