User's Manual

13
(00) INSTANT REPORTING
(01) - (99) DELAY
z Factory Default is (10), 10 SECONDS.
<
<
N
N
O
O
T
T
E
E
>
>
) Emergency alarm cannot be cancelled
after the Guard Time is elapsed.
) The Guard Time Delay for Fall Sensor
is set by Command 66. Command
66 is used if a fall is detected.
) If an emergency alarm is triggered by
pressing the Active Button on Fall
sensor, the guard time delay time is
restricted to Command 42, rather
than Command 66.
) If the Guard Time Delay Time set by
Command 42 is less than the delay
time set by Command 66, the system
will follow the setting of Command 42
to respond accordingly if an alarm is
triggered.
Command 43
Periodic Test Call
z CTC-1052RV can be programmed to make
test calls periodically from (00) (no test call)
to every (1) - (7) or 30 days:
Function Selection Result
(0) OFF
(1) - (7) 1 - 7 DAYS
(8) 30 DAYS
z Factory Default is set as (0), OFF.
<
<
N
N
O
O
T
T
E
E
>
>
) Whenever programming mode is
accessed, CTC-1052RV will reset the
Periodic Test Call timer.
Command 44
Mobility Timer
This function monitors user movement around
the premises and sends an inactivity report to
the Monitoring Center if the user fails to reset
the inactivity timer.
z This will disable or enable the Inactivity
Timer with selectable count down periods.
Options are:
Function
Selection
Result
(00) DISABLE
(01) 1HR
(02) 2HR
..........
.........
(36) 36HR
z Factory Default is set as (00), DISABLE.
<
<
N
N
O
O
T
T
E
E
>
>
) The Mobility Timer counting down can
be reset by:
1. Pressing the RESET button on
CTC-1052RV, or,
2. Movement detected by PIR
Detector
3. Only workable by entering 2 digits.
) When Mobility Timer expires and no
reset signal is received, CTC-1052RV
starts to emit one long beep every 5
minutes to alert the user. After 30
minutes, if reset signal is not received,
a mobility alarm reporting will be made.
) The reporting method for mobility alarm
is the same as the emergency alarm.
The report will be sent based on your
reporting methods without guard time
waiting.
) When (00) is selected, no code is sent
to Monitoring Center.
) When CTC-1052RV is in idle mode,
press and hold the green reset button
for 16 seconds, until you hear a long
beep. Then release the button; the
Mobility function will be disabled.