User's Manual

15
according to the setting of Command 43
－ Test call.
Function
Selection
Result
(1) 1 Hour
(2) 2 Hour
(3) 3 Hour
(4)
4 Hour
(5)
8 Hour
(6) 12Hour
z Factory default is set as (1) 1 Hour. When
the Off-Set Time is reset in programming
Mode, the time of the Off-Set period will
recalculate.
z Off-Set time Report will be sent only once,
and then the Control Panel sends Check-in
Report according to setting of period test
call, unless the Control Panel restarts or
the Off-Set time is reset.
<
<
N
N
O
O
T
T
E
E
>
>
) Whenever programming mode is
accessed, CTC-1052RV will reset the
Off-Set timer.
Command 49
Supervision
This function is not available for the digital
Scancom reporting method.
z This option is used to enable system
Supervision function. Once enabled, CTC-
1052RV will be able to receive the check-
in signals from Wrist Pendants (WTR-) to
indicate their proper functioning.
Function
Selection
Result
(0) Disable
(1) 4 Days
(2) 5 Days
(3) 6 Days
(4)
7 Days
(5)
8 Days
(6) 9 Days
(7) 10 Days
z Factory default is set as (0) Disable. No
code is sent to Monitoring Center.
z When the supervisory timer expires and no
supervision signal is received from WTR-,
the supervisory alarm reporting will be
made.
z The reporting method for supervisory alarm
is the same as the emergency alarm. The
report will be sent based on your reporting
methods without guard time waiting.
Command 60
GSM Band Select
z Depending on your local telecom service
provider’s network setting, you will need to
adjust the GSM band setting accordingly.
Please check with our local telecom
service provider for the appropriate setting.
Function
Selection
Result
(0) Mono-band Mode 850 MHz
(1)
Mono-band Mode
900 extended (900E) MHz
(2) Mono band Mode 1800 MHz
(3) Mono band Mode 1900 MHz
(4)
Dual-band Mode
850/1900 MHz
(5) Dual-band Mode
900 extended (900E)/1800 MHz
(6)
Dual-band Mode
900 extended (900E)/1900 MHz
z Factory default is set as (5) Dual-band
Mode 900 extended (900E)/1800 MHz
(Europe)/ (4) Dual-band mode 850/1900
MHz (U.S.).