User's Manual

19
9 Another device has been learnt-
in before.
<
<
N
N
O
O
T
T
E
E
>
>
) When CTC-1052RV received the alarm
signal from the Silent Pendant, it will
not emit any warning beeps during
Reporting and Guard time period.
Command 94
Learn-In Device
<
<
N
N
O
O
T
T
E
E
>
>
) This command is not available in
Remote Programming Mode.
z Up to 7 devices can be learnt into CTC-
1052RV by using Command #94.
z The available devices that can be learnt-in
Command #94
are:
9 PIR Sensor ----- PIR
9 Smoke Detector ---- SD
9 Carbon Monoxide ---- CO
9 Fixed Panic Button ---- PB
9 Wrist Transmitter ---- WTR
9 Pendant Transmitter ---- WTR
9 Water Sensor ---- WS
9 Fall Sensor
Step 1: Enter 94 + # on the phone set, then
a short beep will be heard via the
phone set
.
Step 2: Press the learn button on the
device within 20 secs.
) Learning can only be completed
within the signal reception range of
CTC-1052RV.
) If no signal is received within 20
sec, CTC-1052RV will emit a long
beep and automatically returns to
Programming mode.
Step 3: CTC-1052RV will emit 2 beeps to
indicate the device is learnt-in
successfully.
) Adding a Pendant for a second
time is prohibited unless it is
removed from the system first.
) If one long beep is emitted
instead of 2 beeps, it indicates:
9 The device has already been
learnt-in.
9 When an 8
th
device is attempted
to learn-in.
Step 4: Repeat steps 1-3 until all devices
are learnt-in.
<
<
N
N
O
O
T
T
E
E
>
>
) Adding a device for a second time is
prohibited unless it is removed from
the system first.
) WTRV is not able to learn-in under this
command.
Command 98
Factory Default Reset
z To Reset CTC-1052RV to factory default
settings, enter (98) and then (#).
z After one short beep, continue by entering
(ÀÀ) and then end with another (#), one
beep will be heard for termination.
z Once the Factory Default Reset is
executed, all the programmed data is
returned to its default value and all the
devices that have been learnt-in are
removed. You have to do the programming
and learn-in the device one by one again.
Command 99
Exit Programming Mode
z Enter (99) and (#), after one short beep,
CTC-1052RV exits the Programming Mode
and returns to idle mode.
3.3. SMS Remote
Programming
<
<
N
N
O
O
T
T
E
E
>
>
) Prior to procced, please be reminded to
change the language setting of your
mobile phone to English.
Step 1: Use your handset and go into the SMS
edit screen.