User's Manual

24
<
<
I
I
M
M
P
P
O
O
R
R
T
T
A
A
N
N
T
T
N
N
O
O
T
T
E
E
>
>
) When an alarm is triggered by any device
(except Talking Pendant Series, WTRV/
WTRVS), please note that the two way
communication is set up between the
Central Monitoring Station and the Control
Panel. If an alarm is triggered by Talking
Pendant Series, the two-way
communication between the Central
Monitoring Station and Talking Pendant
Series.
Alarm Triggered by Talking Pendant Series
(WTRV/ WTRVS)
Press the Active button on a talking pendant to
trigger an alarm. Then you will hear a talking
pendant’s confirming beeps and the beeps will
stop until a talking pendant receives a DTMF
command. If a talking pendant receives a
DTMF command, it indicates that the
connection is setup successfully. While the
WTRV is triggered, 1052RV’s Help Button and
Red button will lighten until connection ends.
<
<
N
N
O
O
T
T
E
E
>
>
) When an alarm is triggered by Talking
Pendant Series (WTRV/ WTRVS), the
two-way communication is set up
between the Central Monitoring
Station and the Talking Pendant.
) When an alarm reporting successfully
goes through to CMS, but if no DTMF
command is received by a talking
pendant, after 2.5 minutes, connection
will timeout and the talking pendant
will stop beeping.
) When reporting to CMS fails, the
talking pendant will go to retry cycle
and its confirming beeps will continue
until it receives a DTMF command or
until a retry cycle.
GPRS Reporting Method
z It is required to use SMS Remote
Programming to set Access Point
Name, IP Address, Port Number,
GPRS/IP Account Number, User
Name, and Password before GPRS
Reporting Method becomes effective.
z Access Point Name (APN): the
name of an access point for GPRS.
Please inquire your SIM card service
provider for your APN.
z IP Address: Central Monitoring
Station server IP
z Port Number: Central Monitoring
Station server port number
z GPRS/IP Account Number: your
account number, as set in Digital
Reporting Method (refer to section 3.2.
Programming Your 1052: Command
10-14)
z User Name: offered by your SIM card
service provider. Please inquire your
service provider for your GPRS
username. If no username is required,
you may skip this step.
z Password: offered by your SIM card
service provider. Please inquire your
service provider for your GPRS
password. If no Password is required,
you may skip this step.
z To disable GPRS Reporting Method:
by removing the IP address, GPRS
reporting becomes ineffective.
Proceed to SMS Remote
Programming and send in this format:
“PROG 1111 TCIP1:”
Where:
PROG = SMS Keyword
1111 = Access Code
TCIP1 = SMS command for IP Address (no
input value means deletion of characters)
Digital Reporting Method
After the alarm reporting is successfully
received by the Monitoring Center, CTC-
1052RV will then follow the choice of
Command #38, to enter Follow-On and/or
Call-Back mode.
z
Call-Back Operation
z If Command #38 is set as Call-Back
(1
) or Follow-On & Call-Back (2), after
alarm is reported to CMS, the system
will then wait 5 mins for Monitoring
Center Personnel to call-back after
reporting.