User's Manual

4
2. Learn-in the Devices
There are two methods to learn in devices:
local learning and command learning. Total
10 sensors (including one talking pendant,
WTRV or WTRVS) are allowed to be learnt
into the system. And only one WTRV/ WTRVS
can be learnt into the system.
Local Learning
:
You can use the local learning method to
learn in 2 devices only. Refere to 2.1
Learning Pendant # 1 to learn in the first
device and then 2.2 Learning Pendant #2 to
learn in the second one.
1. Users can enable CTC-1052RV to get into
the learning mode to learn in WTR- Series,
Fall Sensor or WTRV/ WTRVS.
2. WTRV/WTRVS is only allowed to be learnt
in by using the Local Learning method.
3. If you have learned the first device to the
system by following instructions in the 2.1
section, you are not allowed to use
Command 91 (Command Learning) to
learn in another device.
4. If you have learned the second device to
the sytem as instructed in the 2.2 section,
you are not allowed to use Command 92
(Command Learning) to learn in another
device.
Command Learning
:
1. Users can use Command #91 ~ 94 to
learn in devices into the system,
including PIR Sensor, Smoke Detector,
Panic Button, Carbon Monoxide, Wrist
& Neck Transmitter, Water Sensor,
Pendant Transmitter, WTR- series and
Fall Sensor. Please refer to 3.2
Programming Your 1052RV:
Commands 91-94 for details.
2. You are not allowed to learn in WTRV/
WTRVS by using Command Learning
method.
3. Command 91 is designed to learn in
WTR- Series or Fall Sensor only.
4. Command 92 is designed to learn in
WTR- Series or Fall Sensor only.
5. Command 93 is designed to learn in
WTR- Series or Fall Sensor only for
silent reporitng.
6. Command 94 is designed to learn in
the following sensors:
 PIR Sensor ----- PIR
 Smoke Detector ---- SD
 Carbon Monoxide ---- CO
 Fixed Panic Button ---- PB
 Wrist Transmitter ---- WTR
 Pendant Transmitter ---- WTR
 Water Sensor ---- WS
 Fall Sensor
2.1. Learning Pendant #1
Refer to the following instruciton to learn in the
WTR- Series, Fall Sensor or WTRV/ WTRVS.
For Normal Wrist Transmitters (WTR-) or
Fall Sensor
1. Press and hold the RESET button of
CTC1052RV for 6 seconds until you hear
the double beep and followed by a long
beep.
2. The RED LED starts flashing. CTC-
1052RV is now in the learning mode.
3. Press and both the RESET and Pendant
#1 (WTR- Series or Fall Sensor) buttons
simultaneously until CTC-1052RV emit a
double-beep.
4. Pendant #1 has been learnt-in
successfully.
For Talking Pendant (WTRV/ WTRVS)
1. Press and hold the RESET button of
CTC1052RV for 6 seconds until you hear
the double beep
and followed by a long
beep.
2. The RED LED starts flashing. CTC-
1052RV Pro is now in the learning mode.
3. Press and hold the WTRV/ WTRVS
button for 5 seconds until you hear a long
beep. The WTRV/ WTRVS’s Green LED
turn to RED.
4. The WTRV/ WTRVS is now in the learn
mode.