Installation Instructions

4
 Mounting with mounting plate and rotating holder (Optional):
 A rotating holder is provided as a user friendly mounting option. It is comprised of a base to fix to surface, and a
swivel ball to fix to mounting plate and EIR-32.
 With the rotating holder, the EIR-32 can be rotated in any direction to provide optimal viewing angle.
 To mount EIR-32 with mounting plate and rotating holder:
1) Fix the rotating holder to the wall with provided screws.
2) Fix the mounting plate on the swivel ball with the fixing screw secured through the foolproof design hole.
3) Mount EIR-32 with the hooks of the mounting plate latched on the back cover of the EIR-32, and then push
downwards until you hear a click sound to lock the hook.
4) Insert the protective shield (the protective film from both sides must first be removed).
5) Rotate the swivel ball to adjust EIR-32’s detecting angle.
<
<
N
N
O
O
T
T
E
E
>
>


When the angle adjusting screw is half loosen, the swivel ball can still be rotated.
6) When EIR-32 is rotated to a positon with desired detection angle, you can lock the position by firmly
tightening the angle adjusting screw.
<
<
N
N
O
O
T
T
E
E
>
>

 After EIR-32 is mounted, if the Control Panel displays the Tamper fault status for the device, please make sure the
anti-masking detector is not obstructed by any object and wait for two minutes to see if the Tamper Open status is
cleared. If Tamper Open status persisits after two minutes, please remove EIR-32 from the mounting location, and
check if the Tamper Switch is properly compressed against the mounting plate.