FP‐HUB Installation Guide
Contents 1. Introduction: ......................................................................................................................................... 3 2. Technical Specifications: ....................................................................................................................... 3 3. Setting up the Panel .............................................................................................................................. 3 4. Adding Sensors and Peripherals.........
1. Introduction: About the Panel The FP‐HUB is a wireless headless Security and Home Automation panel. The panel offers full Dual‐Path support via cellular and IP broadband connection,. The panel comes with onboard battery backup available for 24 hours of continued monitoring in the event of a power outage. 2. Technical Specifications: The panel comes with onboard Cellular, RF, Z‐Wave, and Wi‐Fi radios.
. Adding Sensors and Peripherals Security Sensors Security Sensors can only be added to the system locally via a Learn Mode based sensor identification. 1. Press and hold the Auto Learn button for 10 seconds until the panel emits a one‐tone beep to indicate it has entered Learn Mode. The top LED will turn solid GREEN to indicate the panel is in learn mode. 2. Trigger each device following the procedure in the device installation manual. 3.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15,22,24,27 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
