Installation Guide




FPHubInstallationGuideVersion1.0Published6/15/18 4

4.AddingSensorsandPeripherals
SecuritySensors
SecuritySensorscanonlybeaddedtothesystemlocallyviaaLearnModebasedsensoridentification.
1. PressandholdtheAutoLearnbuttonfor10secondsuntilthepanelemitsaone‐tonebeepto
indicateithasenteredLearnMode.ThetopLEDwillturnsolid
GREENtoindicatethepanelisin
learnmode.
2. Triggereachdevicefollowingtheprocedureinthedeviceinstallationmanual.
3. Whenthepane lreceivesasignalfromthedeviceitwillemitatwo‐tonebeeptoindicatethatit
wassuccessfullylearnedintothepanel.
4. When
alldevicesarelearnedin,pressandholdtheAutoLearnbuttononthepanelforone
secondtoexitlearnmode.Thepanelwillemitatwo‐tonebeepandtheLEDSwillturnoffto
indicateithasreturnedtoitsnormalmode.
5. Configurethesensorsremotelyvia
awebportal.
7.WalkTestandDeviceMounting
Oncealldevicesarelearnedin,placethedevicesintheirfinallocationsandrunawalktesttoensure
thatalldevicesaresignalingproperlyintheirfinallocations.
WalkTest
1. EnterWalkTestmode,topLEDwillblinkGREENwhileinWalkTestmode
2. Assensorsare
Activated,theiractionwillappearonscreenandthesensorwillemitatwo‐tone
beep
3. Afterallsensorshavebeentriggered,selectEndWalkTesttoexitwalktestmode.
a. IfasensortriggerdidnotregisterontheWalkTest,trymovingitclosertothecontrol
panelandtriggeritagain.Ifthedeviceworksthen,tryusinganRFrepeatertoextend
therangeofthecontrolpanel.
DeviceMounting
Oncedevicesaresignalingintheirfinallocations,theycanbemountedaccordingtotheinstructions
providedwitheachdevice

5.SystemProgramming
Thesystemsettingscanonlybeprogrammedremotelyviaawebportalorapp.

6.Regulatory
FCCID:GX9FPHUB3
