User's Manual

15

The sensor partition can be edited by selecting “Advanced Sensor Settings”. Choose
new partition for the device and click “Save Changes” to confirm.
 Click “Add Sensor” to learn new sensors, see 4.1. Learning for detail.
 Click “Delete Sensor” to remove device, you will enter device removal page. Select the
device to be removed and click “Send Command” to confirm.
 Click “Walk Test” to access Walk Test function. The Walk Test function allows you to
test signal strength of the device.
I. Click “Begin Walk Test” to put panel into Walk Test Mode.
II. When the panel is under Walk Test mode, activate a learnt in device to send signal
to Panel.