User's Manual

34
Device List and Status: This is found on the “Equipment Section” of the Installer Page, you can
find the list by expanding the relevant Section. Sensor Management will allow configuration of
sensors and peripherals
8.1.3 Restoring Faults
In order to Restore a Fault and remove the Fault Indication, the Fault condition must be
physically resolved and the fault notice must be acknowledged by the Level 2 user at the remote
keypad.
8.1.4 Force Arming the Control Panel
When there is a Tamper or Fault that has not been restored, or a Zone is open/activated the
control panel will give an “Arming Failed” indication. This can be overridden at the remote
keypad by choosing to arm a second time, and on the Alarm.com Webpage by choosing the
“Bypass Open Sensor” option. Please note, any open zones that have been bypassed will
remain bypassed until they are closed.