User's Manual

6
3. Getting Started
Read this section of the manual to learn how to set up your HSGW-Gen2-V1 Panel and program
System Settings over the Web page.
3.1. Hardware Installation
The panel can be either fixed on the wall or placed on deskop. For the panel to meet
requirements of the applicable EN standard, wall mounting installation must be used.
1 Remove the 2 screws that secured the panel casing to the mounting bracket. (Figure 1)
2 Remove the mounting bracket to reveal the back cover fixing screw. (Figure 2)
Figure 1
Figure 2
3 Remove the screw securing the back cover (as circled in Figure 2).
4 Set up the Control Panel though the following steps:
I. Connect Ethernet cable to panel Ethernet port.
II. Insert a functional micro SIM Card into Micro SIM Card Compartment, the SIM Card
PIN Code must be disabled first.
III. Slide Battery Switch to ON position.
IV. Use the AC Power Cord for Built-in S.P.S to to connect to the mains power.
5 Wire the cable, close the back cover and secure it by fastening the screw. Proceed to
mount the panel onto the wall.