User's Manual

 When the panel receives signal again from sensor that previously failed supervision.
 154 – Water leakage
 When the Water Sensor connected to Door Contact set at Water (@W) is triggered.
 158 – High Temperature Alarm
 When high temperature alarm is triggered.
 159 – Low Temperature Alarm
 When low temperature alarm is triggered.
 162 – CO Alarm
 170 – High Power Consumption
 When high power consumption alarm is triggered.
 171 – High Humidity Alarm
 When high humidity alarm is triggered.
 172 – Low Humidity Alarm
 When low humidity alarm is triggered.
 301 – AC Failure/ AC Power Restore
 When the AC power fails for more than 10 sec.
 Restore from AC power failure.
 302 – Low battery/ Battery Normal
 When the battery voltage of the Panel is low.
 When the panel battery restores voltage.
 311 – Battery Disconnection/ Battery Reconnected
 344 – Interference/ Interference problem solved
 358 – Network Cable Unplugged
 When the Ethernet cable is disconnected.
 374 – Force Arm
 When the system is armed with existing fault events
 693 – Cross Zone Trouble
 When Cross Zone Timer expires without alarm verification.
 380 – Device AC Failure
 When an AC power device loses AC power connection.
 383 – Sensor Tamper/ Sensor Tamper Restore
 When any sensor’s tamper protection is triggered.
 When the sensor’s tamper function is restored.
 384 – Sensor Low battery/ Sensor Battery Normal
 When a device detects low battery voltage.
 When a device’s low battery condition is restored.
 400 – Arm/Disarm (by Remote Controller)
 When the system is armed or disarmed by using the Remote Controller.
 401 – Remote Arm/Disarm
 When the system is armed or disarmed by SMS message or web access
106