User's Manual
Table Of Contents
- Table of Contents
- 1. Introduction
- 2. Panel Information
- 3. Getting Started
- 4. Connection to Panel Webpage
- 5. Device Management
- 6. System Settings
- 7. Network Settings
- 8. System Settings
- 8.1. Administrator Setting
- 8.2. Home Automation
- 8.3. Scene
- 8.4. Reporting
- 8.5. Code Settings
- 8.6. SMTP Setting
- 8.7. Media Upload
- 8.8. Polling
- 8.9. XMPP
- 8.10. Date & Time
- 8.11. Dynamic DNS
- 8.12. Test IP
- 8.13 Firmware Upgrade
- 8.14. RF Firmware Upgrade
- 8.15. IO MCU Firmware Upgrade
- 8.16. Factory Reset
- 8.17. Backup & Restore
- 8.18. System Log
- 9. Event & History
- 10. Appendix
- Federal Communication Commission Interference Statement
3.2. Mounting
Before installation or any maintenance work, make sure the power supply has
been disconnected, and the battery switch has been slid to OFF position.
Step 1. Use a flat-head screwdriver to loosen the cover fixing screw to open the top cover.
Step 2. Use the 4 mounting holes as a template to mark and drill holes appropriately.
Step 3. Use the provided wall plugs for plaster/brick installation. Make sure the wall plugs are
flush with the wall.
11