User's Manual
Table Of Contents
- Table of Contents
- 1. Introduction
- 2. Panel Information
- 3. Getting Started
- 4. Connection to Panel Webpage
- 5. Device Management
- 6. System Settings
- 7. Network Settings
- 8. System Settings
- 8.1. Administrator Setting
- 8.2. Home Automation
- 8.3. Scene
- 8.4. Reporting
- 8.5. Code Settings
- 8.6. SMTP Setting
- 8.7. Media Upload
- 8.8. Polling
- 8.9. XMPP
- 8.10. Date & Time
- 8.11. Dynamic DNS
- 8.12. Test IP
- 8.13 Firmware Upgrade
- 8.14. RF Firmware Upgrade
- 8.15. IO MCU Firmware Upgrade
- 8.16. Factory Reset
- 8.17. Backup & Restore
- 8.18. System Log
- 9. Event & History
- 10. Appendix
- Federal Communication Commission Interference Statement
Step 4. Screw the Control Panel onto the wall. Make sure the Tamper Switch is fully
depressed against the wall.
Step 5. Take out Velcro tape(s) from the package. Please note: The number of Velcro tape(s)
required may vary depending on your battery type and capacity.
Step 6. Peel the release film of the tape. Apply it to your battery pack and press firmly for 30
seconds to ensure good contact. Please avoid applying the tape on uneven surface or
re-apply it.
<NOTE>
Apply the Velcro tapes to the back of the battery pack for long-term attachment
Step 7. Complete wiring following the instructions in later section 3.3. Hardware Installation.
Step 8. Arrange all wires along the wire clips and then route the wires to the two cable holes
on top. Use cable ties (not included ) to thread through the wire clips and secure the
wires. Use the U-shaped grommets around the cable holes to manage wires.
-
12