User's Manual
Table Of Contents
- Table of Contents
- 1. Introduction
- 2. Panel Information
- 3. Getting Started
- 4. Connection to Panel Webpage
- 5. Device Management
- 6. System Settings
- 7. Network Settings
- 8. System Settings
- 8.1. Administrator Setting
- 8.2. Home Automation
- 8.3. Scene
- 8.4. Reporting
- 8.5. Code Settings
- 8.6. SMTP Setting
- 8.7. Media Upload
- 8.8. Polling
- 8.9. XMPP
- 8.10. Date & Time
- 8.11. Dynamic DNS
- 8.12. Test IP
- 8.13 Firmware Upgrade
- 8.14. RF Firmware Upgrade
- 8.15. IO MCU Firmware Upgrade
- 8.16. Factory Reset
- 8.17. Backup & Restore
- 8.18. System Log
- 9. Event & History
- 10. Appendix
- Federal Communication Commission Interference Statement
5.
6.
Double-End-of-Line Resistor Wiring
7.
8.
AUX Power Wiring
The Control Panel can provide a maximum of 12V 400mA current for hardwired zones,
auxiliary output,KPT-35-COMBO and wired expansion module ( WEZC-8).
Min/Max operating voltages for devices/detectors is 11.4VDC -13VDC.
Please note that the total current should not exceed 400mA, otherwise, an additional
power supply is required.
16