User's Manual

5. Device Management
The Device Management section allows you to learn in, edit, control and view all available
accessory devices that can be included in the Panel.
5.1. Learning of Devices
Use this function to add new devices into the Control Panel. Hybrid Security Alarm System
supports up to a total of 160 zones of accessory devices, in 2 areas, up to 80 zones each area.
The following types of accessory devices are supported:
 RF device: All Climax RF devices are supported.
 IP Cameras: The Control Panel is compatible with Climax VST-1818 Series IP Camera. Up
to 6 IP Cameras are supported.
5.1.1. Add Sensor
Step 1. Click on “Learning” to enter learn page.
Step 2. Click on “Start” to enter learning mode.
Step 3. Press the test or learn button on the each device or any button on the Remote
Controller. (Please refer to each sensor’s user manual for test or learn button position).
Step 4. Click “Add” to include selected device into panel. If the sensor you wish to learn into
already exists in the system, the sensor information will be displayed in the Learned
Device section. If not, the sensor information will be displayed in the Detected Device
section.
<NOTE>
 For VST-862 F1 devices, press and hold the learn button for 3 seconds for the Control
Panel to receive a learn code, and then click “Add” within 30 seconds.
29