User's Manual

Step 6. If the device is successfully learnt into the system, the added device will be displayed in
the “Learned Device” section.
Step 7. Repeat Step 3~5 to learn in all device, click Stop to exit learn mode when complete.
The system will automatically exit Learn mode if left idle for 5 minutes.
5.1.2. Local Learning
Instead of learning devices via configuration webpage, you can also learn in devices by using
the learn button of the Control Panel.
Step 1. Press and hold the learn button of the Control Panel for 10 seconds, release when the
Control Panel emits one short beep. LED 1 & 2 (Green) will turn ON to indicate the
Control Panel is now in learning mode.
Step 2. Press the test or learn button on each device to transmit signal, refer to device manual
for detail.
Step 3. When the Control Panel receives signal from device, it will emit 2 beeps to confirm. The
device will be included in the panel automatically.
Step 4. After finishing learning all devices, press the button once. The Control Panel will emit 2
short beeps to indicate it has returned to normal operation mode. LED 1 & 2 will dim. If
the user does not press the button within 5-6 minutes, the system will automatically
return to normal operation mode.
<NOTE>
 The Control Panel cannot enter learning mode when under Away Arm/Home Arm or
Walk Test mode. The Control Panel will emit 5 beeps to indicate error.
30