User's Manual
Table Of Contents
- Table of Contents
- 1. Introduction
- 2. Panel Information
- 3. Getting Started
- 4. Connection to Panel Webpage
- 5. Device Management
- 6. System Settings
- 7. Network Settings
- 8. System Settings
- 8.1. Administrator Setting
- 8.2. Home Automation
- 8.3. Scene
- 8.4. Reporting
- 8.5. Code Settings
- 8.6. SMTP Setting
- 8.7. Media Upload
- 8.8. Polling
- 8.9. XMPP
- 8.10. Date & Time
- 8.11. Dynamic DNS
- 8.12. Test IP
- 8.13 Firmware Upgrade
- 8.14. RF Firmware Upgrade
- 8.15. IO MCU Firmware Upgrade
- 8.16. Factory Reset
- 8.17. Backup & Restore
- 8.18. System Log
- 9. Event & History
- 10. Appendix
- Federal Communication Commission Interference Statement
A sensor set to 24HR attribute will ignore Disarm, Full Arm, Home are and Exit
response setting. The panel will activate selected alarm when this sensor is
triggered regardless of system mode under any time.
<NOTE>
Some devices have their own unique functions and will have its own attribute setting
which is not listed in this section. Please refer to the device manual for its setting detail.
5.1.4. Delete Devices
Step 1. To delete a sensor, click “Delete” under “Device List”
Step 2. A message “Delete success” is displayed and the sensor you choose is deleted
successfully.
5.1.5 Learning of Expansion Boards (WEZC-8)
Step 1. Connect the expansion board to the Control Panel. Then, power on the Control Panel.
Step 2. Click on “Learning” to enter learn page.
Step 3. Click on “Start” to enter learning mode.
35