User's Manual
Table Of Contents
- Table of Contents
- 1. Introduction
- 2. Panel Information
- 3. Getting Started
- 4. Connection to Panel Webpage
- 5. Device Management
- 6. System Settings
- 7. Network Settings
- 8. System Settings
- 8.1. Administrator Setting
- 8.2. Home Automation
- 8.3. Scene
- 8.4. Reporting
- 8.5. Code Settings
- 8.6. SMTP Setting
- 8.7. Media Upload
- 8.8. Polling
- 8.9. XMPP
- 8.10. Date & Time
- 8.11. Dynamic DNS
- 8.12. Test IP
- 8.13 Firmware Upgrade
- 8.14. RF Firmware Upgrade
- 8.15. IO MCU Firmware Upgrade
- 8.16. Factory Reset
- 8.17. Backup & Restore
- 8.18. System Log
- 9. Event & History
- 10. Appendix
- Federal Communication Commission Interference Statement
countdown. If deselected, the panel will activated burglar alarm and report
immediately when the sensor triggered during Exit Delay Timer.
24HR
A sensor set to 24HR attribute will ignore Disarm, Full Arm, Home are and Exit
response setting. The panel will activate selected alarm when this sensor is
triggered regardless of system mode under any time.
<NOTE>
Some devices have their own unique functions and will have its own attribute setting which is
not listed in this section. Please refer to the device manual for its setting detail.
Step 7. If you want to delete the sensor, refer to step 2 and select “Disabled” from the drop
down menu of Type to delete it. If the process is successful, the screen will display
“Updated Successfully.”
55