User's Manual
Table Of Contents
- Table of Contents
- 1. Introduction
- 2. Panel Information
- 3. Getting Started
- 4. Connection to Panel Webpage
- 5. Device Management
- 6. System Settings
- 7. Network Settings
- 8. System Settings
- 8.1. Administrator Setting
- 8.2. Home Automation
- 8.3. Scene
- 8.4. Reporting
- 8.5. Code Settings
- 8.6. SMTP Setting
- 8.7. Media Upload
- 8.8. Polling
- 8.9. XMPP
- 8.10. Date & Time
- 8.11. Dynamic DNS
- 8.12. Test IP
- 8.13 Firmware Upgrade
- 8.14. RF Firmware Upgrade
- 8.15. IO MCU Firmware Upgrade
- 8.16. Factory Reset
- 8.17. Backup & Restore
- 8.18. System Log
- 9. Event & History
- 10. Appendix
- Federal Communication Commission Interference Statement
6.3. PIN Code
The User PIN Codes are used by Remote Keypad accessory to control system mode remotely.
The 2 areas in the control panel each has 80 User PIN Codes available for setting. Each
consists of 4-6 digits (numeric number 0~9), no disallowed PIN code. User PIN code #1 for each
Area is always activated factory default.
User PIN #1 in Area 1 User PIN #1 in Area 2
Password: 1234 Password: 4321
Area
Area: Select the area for setting User PIN Code.
User Code Setting
User Code: Enter the 4-digit code in the field.
User Name: Enter a user name for easy recognition of system events. Up to 17
alphanumerical characters are allow for each user name.
Latch:
Latch Latch Report ON = Whenever the User PIN Code is used to change
system mode, the panel will report the event.
Latch Latch Report OFF = When the User PIN Code is used to change system
mode, the panel will not report the event.
Delete: Check the box if you want to delete selected user. User#1 in each area cannot
be deleted
After finish all setting, click OK to confirm change.
63