User's Manual
Table Of Contents
- Table of Contents
- 1. Introduction
- 2. Panel Information
- 3. Getting Started
- 4. Connection to Panel Webpage
- 5. Device Management
- 6. System Settings
- 7. Network Settings
- 8. System Settings
- 8.1. Administrator Setting
- 8.2. Home Automation
- 8.3. Scene
- 8.4. Reporting
- 8.5. Code Settings
- 8.6. SMTP Setting
- 8.7. Media Upload
- 8.8. Polling
- 8.9. XMPP
- 8.10. Date & Time
- 8.11. Dynamic DNS
- 8.12. Test IP
- 8.13 Firmware Upgrade
- 8.14. RF Firmware Upgrade
- 8.15. IO MCU Firmware Upgrade
- 8.16. Factory Reset
- 8.17. Backup & Restore
- 8.18. System Log
- 9. Event & History
- 10. Appendix
- Federal Communication Commission Interference Statement
Request Image (No Flash): The PIR Camera in specified zone will take a
picture.without activating its LED flash.
Request Image (All, No Flash) : All PIR Cameras in the system will take a picture
without activating LED Flash.
Request Video : The PIR Video Camera or IP Camera in specified zone will record a
video.
Request Video (All) : All PIR Video Cameras and IP Cameras in the system will
record a video.
Setup UPIC:: The UPIC and specified zone will transmit Off/Heat/Cool command to the
air conditioner as programmed.
Hue Control:: Adjust the hue and saturation of the Philips Hue at sepecified zone as
programmed.
Trigger Alarm: Choose to activate one of the following alarms: High Temperature
Alarm, Low Temperature Alarm, High Power Consumption Alarm, High Humidity Alarm
and Low Humidity Alarm
Apply Scene:: the system will execute preprogrammed Scene number. Please refer to
8.3. Scene for detail.
Hue
Saturation
74