User's Manual
Table Of Contents
- Table of Contents
- 1. Introduction
- 2. Panel Information
- 3. Getting Started
- 4. Connection to Panel Webpage
- 5. Device Management
- 6. System Settings
- 7. Network Settings
- 8. System Settings
- 8.1. Administrator Setting
- 8.2. Home Automation
- 8.3. Scene
- 8.4. Reporting
- 8.5. Code Settings
- 8.6. SMTP Setting
- 8.7. Media Upload
- 8.8. Polling
- 8.9. XMPP
- 8.10. Date & Time
- 8.11. Dynamic DNS
- 8.12. Test IP
- 8.13 Firmware Upgrade
- 8.14. RF Firmware Upgrade
- 8.15. IO MCU Firmware Upgrade
- 8.16. Factory Reset
- 8.17. Backup & Restore
- 8.18. System Log
- 9. Event & History
- 10. Appendix
- Federal Communication Commission Interference Statement
If reporting to all destinations in a group fails, the system will retry reporting to the group
according to the retries times set here.
<NOTE>
When the panel is registered into Climax’s Home Portal Server, URL1 will be filled in
with Home Portal Server report information. Do not change the information once
registration is complete or reporting to Home Portal Server may encounter error.
After registering the panel in Home Portal Server, if you wish to set more reporting
destination, the new report destination should be set to different group than URL1
otherwise it may not be able to receive report successfully.
79