User's Manual
Table Of Contents
- Table of Contents
- 1. Introduction
- 2. Panel Information
- 3. Getting Started
- 4. Connection to Panel Webpage
- 5. Device Management
- 6. System Settings
- 7. Network Settings
- 8. System Settings
- 8.1. Administrator Setting
- 8.2. Home Automation
- 8.3. Scene
- 8.4. Reporting
- 8.5. Code Settings
- 8.6. SMTP Setting
- 8.7. Media Upload
- 8.8. Polling
- 8.9. XMPP
- 8.10. Date & Time
- 8.11. Dynamic DNS
- 8.12. Test IP
- 8.13 Firmware Upgrade
- 8.14. RF Firmware Upgrade
- 8.15. IO MCU Firmware Upgrade
- 8.16. Factory Reset
- 8.17. Backup & Restore
- 8.18. System Log
- 9. Event & History
- 10. Appendix
- Federal Communication Commission Interference Statement
8.16. Factory Reset
Yan can clear all programmed parameters in the Control Panel and reset it to Factory Default.
Once the Factory Reset is executed, all the programmed settings will returned to its default
value, and all the learnt-in devices will be removed. You will need to restart the programming
and learning process again.
8.16.1 Remote Reset
Step 1. Tick the Kept current network setting to keep the current Network settings.
Otherwise, the system will reset its value back to factory default. Tick the Kept
current device list box to keep the current learnt-in devices. Otherwise, the system
will reset its value back to factory default.
Step 2. Press Yes to continue the Reset procedure.
Step 3. Wait for 1 min and do NOT power off during this time.
Step 4. Once reset is complete, it will automatically reboot the main unit.
8.16.2 Local Reset
Step 1. Slide battery switch to OFF.
Step 2. Press and hold the learn button.
Step 3. Keep holding the reset button until you hear continuous beeps. The 3 LEDs will flash 3
times.
Step 4. Release the button and wait for the Control Panel to reboot.
92